Finally I brought to mind

Finally I brought to mind

And here so I did not tear away from the car, when I'm in the heat it repaired ...

Finally I brought to mind

that ksenon.horoshaya shtuka.Sravnival with native bulbs (not halogen, namely light bulbs) - do not know how my dad and our parents in my time with them we went ...

Finally I brought to mind

...

well, a complete overhaul engine (native liner pierce a first size), restoring all-pitman arm spraying. camshaft, crankshaft under the 1st and size main and connecting rod. Guys.I tell you that as much as he did not expect that so well moskvichenok can go. Under asshole I give him on the rare occasions when some moron decides that he is more expensive machine. Very dynamic. works very tiho.rul-not as in a foreign car (just spun and have turned 180), but obeys the slightest touch steering, simply do not have such a sharp movement, the slightest deflection. Well, it is not his fault, but the developers, for which at that time were other definitions and standards. In general ride it was even pleasant. Restore to the original wiring, all soldered.No twists ... I made through the selection switch backlight priborov- native or UV diodes (very nice). Red tape diode (red car) is connected (connected in parallel) in the door opening (with lights interior lighting) .Ele buttons found doorways. diodes hidden so that only the red light was visible, but could not see themselves diodes, then the light turns myagkim.Tak is made and blue diodes from tumbera to go in was a soft blue color. Highlighting the glove compartment white powerful diode. And rear running lamp replaced the powerful diode (500 g). With tinted windows seen everything as day. And he put the bi-xenon headlights in the new. The ride home was much priyatney.Hochu lights once sprayed (to pay) - all the same it will be pleasant, code stamped parts or painted 1977 as a tank even on the sensor 5 - 77g embossed ... Did stove (lathe machined PTFE bushings instead of bearings holders in your own little engine 1977), all tied into bundles of wire and put it in the rapids, and everywhere vyhody- through the gum, so as not to korotnulo. Now raising mats- not see any provoda.Ezdil on the water, and after each winter I have somewhere proceeded. But the worst was the water itself intra- gave either scale, but whether pesok- 4th sleeve at 80 percent was compacted sand, and of course not omyvalas.1-I- due to engine tilt, 20 percent was in the sand .Temperaturu less than 90 never held. After repairs - only antifreeze, and at 10 degrees outside at constantly closed shutters - is not gaining more than 80. when the plug was 82-83 maximum (fully closed blinds). Once again povtoryus- ride was sooo nice. easily. Then upload a photo of interior illumination.

No Comments Yet.

Leave a comment