Another pechkokorch built and spent another and maintenance
here you can look how I installed the fan from shevrolenivy barrel is all good but down at the feet of vseravno was somehow weak. so I was a little thought decided to change the design
fan had to be set as close as possible to the wall and had to make a small podium

furnace case

furnace case

and one updated fan diffuser

furnace case

furnace case

which is quite useful nonweak increased airflow

but for some reason, the heat was not enough. although previously oven pretty well warmed ... and sitting somehow in YouTube, I came across a video


which explains the cold reason
and typing courage, I repeated described as a procedure

furnace case
we reveal

furnace case pull the look
and that's it. several tubes are clogged, which causes the appearance of the dead (cold) zones in the radiator

for reference: spiral data intended for fluid flow turbulence in the pipe which increases the heat transfer

and then I remembered that was once flooded cooling system sealant, so he then scored the tube

wash and put everything in place

furnace case

furnace case

well, and the result was not long in coming. stove start to heat at idle during off Electropomp. temp behind at -35 degrees

a few words about Electropomp:

furnace case

photo but someone else pump takayazhe

latest Bosch with bezsalnikovym execution (magnetic gearing) that leak can not, in principle, but its performance is about half are two times less than the pump gazelevskoy

this problem, I decided to raise the supply voltage pump (this method is tested Flash-Cadillac at its Volga)
the basis of the timer circuit 555 operating mode has been takenGenerator

furnace case

by pumping droselya L1 and the self-inductance voltage rises. voltage is selected at 18 volts which puts boshpompu performance gazelevskoy pump

furnace case

this the device can be switched off so I had the oven temperature adjustment
Low - pump off
Med - the pump is turned on at 12c
Hi - pump oN to 18c

was warm and comfortable! and blowing where it is necessary and how to

No Comments Yet.

Leave a comment