3D printing for "snake"

Hello!

started to address the issue of walking backstage PPC. First, I set out to find the original vtulochek and crackers. I found there was only one under the ball of the scenes. In the picture she is at number 21 . But! our machines not only her problem, as well as being more divided vtulochki № 26 . The new find is not real, and if they slip, then the exorbitant prices, in an area of ​​500 rubles for one. Therefore, someone like collective farms with them. On the Internet a lot of different ideas.

3D printing for "snake"

Without hesitation, I went to another means. At work, there is a 3D-printer in my office, which is mainly not used. For what he bought, known only favorites. As a result, he was covered with dust. Well Well, wipe, open, loads of plastic and run your my computer to remember the lessons on "Compass 3D".

3D printing for "snake"

After 20-30 minutes the sleeve is drawn with calipers, donor bushings and some mothers. The turning point in the desired format (STL), by creating a print job and clicking a button to send go to drink coffee in the snack bar!

3D printing for "snake"

After 20 minutes at medium quality printing came into being the first model. Measurements. Tolerances are correct. Adds millimeter processing and weakness of the original sleeve.

3D printing for "snake"

Next, you print the blank gearshift knob. The output setting. I look forward to the success of this operation.

All or a nail or rod!

No Comments Yet.

Leave a comment