Assembly and installation of the reduced generator on cars

And so everything is ready all the parts are assembled.

Assembly and installation of the reduced generator on cars

Everything is ready for assembly and installation), go to the garage)
You can break to replace the rings, they cut down a chisel we clean everything stuffing new on solder wire, you can still ping to make sure to turn the new bearings) I hope not no secret that the new bearings are sure to lubricate as manufacturers zhopyatsya and put grease nothing at all) general picture is very small, and the finished result as the photographing was not very convenient)

Assembly and installation of the reduced generator on cars

New rings on the spot) Clean shkurochkoyby soldering and forth)
I forgot to say that the war does not without belt replacement) because after a set time of another generator that began whistling) must match) Well, in general I'm not a small thing and took a new generator and an amplifier like the two take Gates, but in the amount of 1025 Gates was not) took Bosch but 800 teeth on hydraulic gates found)

Assembly and installation of the reduced generator on cars

Boxes from belts)

Assembly and installation of the reduced generator on cars

The assembly process is in full swing) Places where necessary contact with the casing stripped) and contactpresent)

Assembly and installation of the reduced generator on cars

The assembly process is in full swing) Places where necessary contact with the casing stripped) and the contact is present)

Assembly and installation of the reduced generator on cars

The assembly process is in full swing) Places where necessary contact with the casing stripped) and the contact is present)

Assembly and installation of the reduced generator on cars

Ready result generator ready to spin in the car)

Assembly and installation of the reduced generator on cars

Ready result generator ready to spin in the car)
After the performed manipulation me via installed on cars, he took the place of honor and became proud to issuetselh 13.7-13.8 under full load (4 position oven, heating glass, high beam, music wipers) And output at idle and 14.4 from the generator to the battery shows 14.3) In general I am very satisfied, and finally I have the normal charge. Now we have to buy at last after a new battery and make war with the stove as it saddens me his behavior) thank you all for your attention) and good luck in your battles) and of course plenty of wins)

Assembly and installation of the reduced generator on cars

Charging under load!

Assembly and installation of the reduced generator on cars

Since it is installed on the machine)

Assembly and installation of the reduced generator on cars

For two-sided adhesive tape was returned to the original sticker that patted life)

Assembly and installation of the reduced generator on cars

on the machine type)

No Comments Yet.

Leave a comment