Improving the work of the heater.

Improving the work of the heater.

a long time did not write anything in the BZ, but with the unexpected arrival of the Russian winter again, it's time to rework! After a short rework the cooling system (already mentioned before) engine began to warm faster but the heater still very much buzzing especially at high speeds, and I decided to take a lot of rework his dorabotat.Prosmotrel heaters from other members of our community and decided not particularly zamorachivatsya, and also set instead of the standard fan snail.This required Vykusi clippers on OEM lower housing stove unnecessary plastic parts and mark the approximate mounting motor of snail drilled several otverstiy.motor snail I drove a close friend, he was with some Japanese (brand unknown) for its attachment I had to make a collar two strips of thick but not metalla.Rodnaya durable plastic cover had a very large hole in diameter so the new impeller cover manufactured from sheet dyuralki (cover of the washing machine's oldest), the thickness of 1.5 mm.in the middle of a round hole cut a slightly smaller diameter of the impeller intake vozduha.Po sides in the housing drilled two holes and pasted them on the two pipes Sanitary plastic comb and docked two outside corner for the hot air in the direction of the driver and passenger foot .Gasyaschy resistor two spirals inserted in the slotted hole in the stove body slightly away from the staff also picked up some Japanese car make unknown.It turned out as a result of three speeds, but have not yet found a stove speed switch with priors, viburnum, etc (well, not in our area of ​​detalek sales) and is left to staff two positions just left the average speed and impeller polnye.Duet perfectly! Motor noise not as before, only the air whistling, pictured below, is useful if someone will call rad.Esli unclear tell more.

No Comments Yet.

Leave a comment