Cabin Renovation: replacement threshold, extractor hood racks, painting

Cabin Renovation: replacement threshold, extractor hood racks, painting

herded into boxing at work.
End of December, almost no orders. Time and place there.
Rigid Coupling the first snow. The front wheels they rule only in one direction from zero. Poh, finally can not helm. Bald-druganchik on Atlas'e pulls!
Here we are, Sunset, placed in labeled "angle".
Washed, cleaned, something sandblasting processed. Etch podkapotku, painted. 2k alkyd enamel, because the other was not at hand.
Threshold carved, produced a new sheet of HC 1.25 mm. Welded. Shpatlya, primer, etc.
Rack first pulled a slide hammer. Do not go.
Cut out the outer layer of a metal that has already been covered in holes (a hole is a hole irregular geometric shape).
I pull back again. Went. But from a blow to the tree is gone, all left-hand side (in the direction of motion). This became evident in the gap established by the door.
Using hydraulics pull (to expand) their left. Day. Measure the diagonal and adding voltage pitching pump. With the stock on the back strain naturally.
achieved the desired clearance. Shpatlyanul tap and a couple of battle scars.
Prepared for painting.

No Comments Yet.

Leave a comment